主题 : 为什么我的U盘模块通过动态加载 不能读取??? 复制链接 | 浏览器收藏 | 打印
级别: 新手上路
UID: 16352
精华: 0
发帖: 32
金钱: 160 两
威望: 32 点
综合积分: 64 分
注册时间: 2010-03-16
最后登录: 2013-07-17
楼主  发表于: 2011-03-22 22:29

 为什么我的U盘模块通过动态加载 不能读取???

我直接 modprobe usb-storage

看到下面的:
[root@FriendlyARM /]# usb 1-1.3: USB disconnect, address 6
usb 1-1.3: new full speed USB device using s3c2410-ohci and address 7
usb 1-1.3: New USB device found, idVendor=0951, idProduct=1625
usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1.3: Product: DT 101 II
usb 1-1.3: Manufacturer: Kingston
usb 1-1.3: SerialNumber: 0013729B678DF97176110A7D
usb 1-1.3: configuration #1 chosen from 1 choice
scsi3 : SCSI emulation for USB Mass Storage devices
scsi 3:0:0:0: Direct-Access     Kingston DT 101 II        1.00 PQ: 0 ANSI: 2
sd 3:0:0:0: Attached scsi generic sg0 type 0
sd 3:0:0:0: [sda] 7827392 512-byte logical blocks: (4.00 GB/3.73 GiB)
sd 3:0:0:0: [sda] Write Protect is off
sd 3:0:0:0: [sda] Assuming drive cache: write through
sd 3:0:0:0: [sda] Assuming drive cache: write through
sda: sda4
sd 3:0:0:0: [sda] Assuming drive cache: write through
sd 3:0:0:0: [sda] Attached SCSI removable disk

[root@FriendlyARM /]# ls
bin         home        lost+found  proc        sys         var
dev         lib         mnt         root        tmp         www
etc         linuxrc     opt         sbin        usr
[root@FriendlyARM /]#

这里面没udisk?
怎么办???
级别: 侠客
UID: 45756
精华: 0
发帖: 56
金钱: 290 两
威望: 58 点
综合积分: 112 分
注册时间: 2011-05-07
最后登录: 2016-01-25
1楼  发表于: 2011-12-23 22:11
也遇到同样问题了。