mini2440 nor flash 格了，下supervivi_mini2440没有选项，只能手动分区了，板子买来还没有跑过WINCE，所以想先跑下images里的WINCE，分区采用的：
bon part 0 192k 1216k
分别用命令下载VIVI，EBOOT，WINCE内核。
启动结果：
VIVI version 0.1.4 ([url=mailto:root@capcross]root@capcross[/url]) (gcc version 2.95.3 20010315 (release)) #0.1.4 Mon Oct 27 10:18:15 CST 2008
MMU table base address = 0x33DFC000
Succeed memory mapping.
DIVN_UPLL0
MPLLVal [M:7fh,P:2h,S:1h]
CLKDIVN:5h
+---------------------------------------------+
| S3C2440A USB Downloader ver R0.03 2004 Jan |
+---------------------------------------------+
USB: IN_ENDPOINT:1 OUT_ENDPOINT:3
FORMAT: <ADDR(DATA):4>+<SIZE(n+10):4>+<DATA:n>+<CS:2>
NOTE: Power off/on or press the reset button for 1 sec
in order to get a valid USB device address.
NAND device: Manufacture ID: 0xec, Chip ID: 0x76 (Samsung K9D1208V0M)
Could not found stored vivi parameters. Use default vivi parameters.
Press Return to start the LINUX/Wince now, any other key for vivi
Copy linux kernel from 0x00050000 to 0x30008000, size = 0x00200000 ... done
Warning: this binary is not compressed linux kernel image
zImage magic = 0xffffffff
Setup linux parameters at 0x30000100
linux command line is: "noinitrd root=/dev/mtdblock2 init=/linuxrc console=ttySAC0"
MACH_TYPE = 782
NOW, Booting Linux......
我想是不是分区错了，但却不知道原装里的WINCE映象里，分区是怎么分的?
