菜鸟求助：
移植ma111无线网卡到s3c2440,内核2.6.14的问题
[root@qqmk]# insmod p80211.ko
Using p80211.ko
Reading data from NAND FLASH without ECC is not recommended
p80211: no version for "struct_module" found: kernel tainted.
p80211: No versions for exported symbols. Tainting kernel.
[root@qqmk]# insmod prism2~1.ko prism2_doreset=1
Using prism2~1.ko
Reading data from NAND FLASH without ECC is not recommended
prism2usb_init: prism2_usb.o: 0.2.7 Loaded
prism2usb_init: dev_info is: prism2_usb
usb 1-2: reset full speed USB device using s3c2410-ohci and address 2
usbcore: registered new driver prism2_usb
[root@qqmk]# ./wlanctl -ng wlan0 lnxreq_ifstate ifstate=enable
Reading data from NAND FLASH without ECC is not recommended
The cmd 'wlan0' is invalid
但是我用ifconfig可以发现wlan0
[root@qqmk]# ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:00:00:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:53 Base address:0x300
lo Link encap:Local Loopback
LOOPBACK MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 00:00:00:00:00:00
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
请大侠们赐教！！！
ps、p80211.ko、prism2_usb.ko、wlanctl三个文件放在一个文件夹有问题吗？我看到有的高手的文档写着“对应”文件夹。
